Coast Spas Classic Series, Owner'S Manual

Page: 17 / 32

17
INITIAL START-UP
Your spa will enter Priming Mode (PR) when it is energized.
During Priming Mode, press “Jets” button repeatedly and be
sure the pump is free of air. Priming Mode lasts less than 5
minutes. Press “Warm” or “Cool” to exit. After Priming Mode,
the spa will run in Standard Mode (see Mode section).
TEMP CONTROL
(80°F - 104°F / 26°C - 40°C)
The last measured water temperature is constantly displayed.
The water temperature displayed is current only when the pump
has been running for at least 1 minute. To display the set tem-
perature, press “Temp” once. To change the set temperature,
press the temperature button again before the display stops
flashing and hold. The set temperature will begin to rise, re-
lease the button at the desired set temperature. To decrease
the set temperature, press and hold the “temp” button again
and the set temperature will decline, release at the desired set
temperature.. After three seconds, the display will stop flashing
and begin to display the current spa temperature. The spa will
then begin heating (or cooling) in order to reach the set temper-
ature that you have selected.
PUMP
Press “Pump” to turn the pump on or off, and to shift between
low and high speeds (if equipped). If left running, the pump will
turn off after a preset length of time. Low speed may run auto-
matically at times as part of your spas filtration cycles, during
which it cannot be deactivated from the panel, however you will
still be able to control the high speed setting. The ozone gener-
ator (if installed) will activate anytime low speed is running.
AUX (PUMP 2)
If an additional pump or blower is installed. Press “Aux” to turn
the device on. If your additional
device is a dual speed pump, pressing “Aux” again will activate
the pumps high speed. Pressing “Aux” again will turn off the
device/pump.
LIGHT
Press “Light” to operate the spa light. Turns off after 4 hours. If
your hot tub is equipped with a multicolor lighting package,
then pressing the “Light” button consecutively will toggle the
lights through different colors modes.
MODE
Mode is changed by pressing “Temp” then “Light”. Press the
“Temp” button to toggle through the available modes. Press
“Light” to exit programming.
Standard Mode
maintains set temperature. “ St ” will be dis-
played momentarily when you switch into Standard Mode.
Economy Mode heats the spa to the set temperature only
during filter cycles. “ Ec ” will display when water temp is not
current, and will alternate with water temp when the pump is
running.
Sleep Mode heats the spa to within 20°F/10°C of the set
temperature only during filter cycles. “ SL ” will display when
water temp is not current, and will alternate with water temp
when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the spa is
energized. The second preset filter cycle begins 12 hours later.
Filter duration is programmable for 2, 4, 6, 8 hours, or C for
Continuous (all day). The default filter time is 2 hours. To pro-
gram, press “Temp” then “Pump”. Press “Temp” to adjust.
Press “Pump” to exit programming.
Classic Topside Quick Reference Card
Main Pump
Auxiliary Pump
Lights
Temperature