PLEASE READ THESE INSTRUCTIONS BEFORE
INSTALLING, COMMISSIONING AND USING THIS
APPLIANCE.
The Coalbrookdale Rembrandt 18G/L Gas Fire is a
decorative fuel effect fire and is intended for decorative
use only. It is is factory set to operate on natural gas
(N.G.) or propane (L.P.G.) (See data label), they are not
interchangeable, please check before use. It must be
fitted into a fireplace having a minimum flue opening of
150mm diameter
Due to newness the fire may give off a slight smell for a
short period after commissioning. This is quite normal
and will disappear after a few hours operation, open
windows and door if required.
NOTE:
No additional coals to be used other than those
supplied with the fire.
NOTE:
THE CERAMIC FIBRE BLANKET SHOULD NOT
BE REMOVED FROM THE BURNER.
NOTE:
The appliance has a gas consumption similar to
that of a small boiler (i.e. 37500 Btu (11kW). Therefore it
is essential that the gas supply pipe work, is of a size that
will allow for the correct flow rate (See TECHNICAL DATA
for required flow rates and pressures). Ideally the 8mm
connection pipe to the burner should be as short as
possible and the maximum length should not be greater
than 1m, also ensure that the isolating tap does not have
a reduced bore.
NOTE:
This appliance must not be fitted in any room
where steam is present (e.g. bathroom).
INTRODUCTION
7
Summary of Contents for REMBRANDT 18G/L
Page 6: ...Users Guide 5 ...
Page 12: ...Installation and Servicing Section 11 ...
Page 24: ...PLACE 5 SMALL COALS AS SHOWN DESN 512254 FIG 23 23 ...
Page 28: ...27 ...
