25
Feed Rate
Spindle Rate
Indicates the exact, real-time cutting speed of the machine in
millimeters per minute (mm/min). In G-code programming, the
feed rate value is found in the G01 (or G1) line.
Indicates the exact, real-time rotational speed of the spindle in
revolutions per minute (RPM).
If you have an unloading table:
On rare occasions, the G01 changes its value during unloading
when it triggers a sensor by accident. In this case, you would need to manually press 100% again
to make sure the machine runs the next file properly.
Changes to these values will immediately take effect upon pressing the buttons while the
machine is in operation. NEVER stop the machine while the router or drill bit is inside your
material as it may cause fire.
G00 Over
SP Over
G01 Over
Press on the numbers with the +/- sign to change values. The new values will appear in the adjacent white box. By
default, the rates are set to 100% of the speed indicated in your G-code.
Increases or decreases the rapid movement (or travel speed) of
the machine in increments of 25%, from 0% to 100%.
Increases or decreases the spindle rate in increments of 10%,
from 50% to 120%.
Increases or decreases the cutting feed rate in increments of
10%, from 10% to 150%.
Summary of Contents for PYTHON XPR
Page 1: ... U S E R G U I D E ...
