CNC Hager Impressivo, Instructions Manual

Page: 9 / 20

9
- Next steps Please read carefully and completely,
because they contain very important details for proper construction.
- Both halves are simultaneously to built up.
- The root rib (consisting of F1, F2 and F3) using
the aluminum tubes F9 together.
Procedure:
- The somewhat deburring aluminum tubes F9 in the appropriate
Mounting holes (see map or picture threading).
- Test ways F1 - composed F3 succession.
If everything fits, use the superglue and repeat.
When bonding ensure that there is no glue on the aluminum tubes,
they are used initially only for mounting.
Also no glue allowed in the area where later
Nose and end strips is inserted.
Since it adversely affect the fit.
- Note: The mounting holes of F1 - F3 are necessary to ensure
the correct offset of the "receiving holes for the aluminum tube arises.
Only then later formed the right slant of the root rib
to the fuselage.
Attention:
The following construction phase has a right and left side.
- The carrier ribs F4, F5 and F6 keys together. Here do the same
as in the root ribs F1 - F3.
(Please watch right and left.)
- Note: Do not glue to the aluminum tube to raise the aspect ratio.
The area of vertical tail intake should remain without adhesive!
A
B
Building wings