CNC Hager Impressivo, Instructions Manual

Page: 19 / 20

19
Completion of the Model
- The extension leads 50 cm (included in delivery) in the wings
do not draw.
- If everything fits, the model can be covered at its own discretion.
(All test models were covered with Oracover.)
- The oars should become ironed, because scotch tape could
free itself with high speeds.
- The foil in the mortising of the wings and side tail units remove carefully
(wood under it not slit!).
- The foil in the body in the area of the root rib something remove, so that a
Splice originates for the next wedding (wings push open and draw with
a pencil the rib contour).
- Carbon tubes R24 in the hull insert and communicate.
- Pipes clog with trunk.
- Slow enough glue (Epoxy, white glue, resin)
enter into the aluminum tubes.
- Thick superglue in the root rib area apply.
- Hull put on flat surface and threading both wings.
- Thread the cable into the trunk and put off both wings evenly.
Ensure that any different angle formed by
eventual game in the pipes.
- Glue wings to the fuselage.
- Rudders insert, align and glue.
- Air intake R26 paste.
- Fasteners at the paste into the lid.
- RC Engines and install (see map).
- Determine the exact focus (see Figure A and Plan).
- Rudder settings to make recommendation (See Figure B).
- Antenna installation, in its discretion.
Assembly