CNC Hager Impressivo, Instructions Manual

Page: 11 / 20

11
- The following steps are initially set only!
- The inner surface stick together gently.
Consisting of F1 - F3, F4 - F6, F7, F8 and F9.
(Please watch right and a left wing.)
Both tailboom F4 - F6 to look up.
The aluminum insert tubes F9.
The inclination of the ribs again and again compare with the plan.
- The wing with F10 - F15 by plugging together expand.
For F10 - F11 can be decided whether the rudder top
or to be articulated to the bottom.
(see Section A - A on the plan)
The test models were always articulated below.
- The bar F16 gently and evenly from
stuck inside to the outside of the ribs.
- Chamfer on both ends of Carbon pipe F17 somewhat obliquely.
Note: Unfortunately, it is technically still part of the supplier
possible to completely get coal straight pipes, since they also
subject to certain tolerances. Please enter pipe before installation to
flat surface and roll mark the highest point in the middle.
The marked spot has to be installed in the direction of leading edge
rotate. So both surfaces have a slight arc-shaped
to the rear which is not a problem.
- CFK tube F17 carefully and always with
Screw rotating movement rib for rib.
A - D