CNC Hager Impressivo, Instructions Manual

Page: 1 / 20

1
Impressivo
All rights reserved. Reproduction and commercial use of these instructions are not allowed.
For consequential damages that may result from the operation of our model aircraft,
will assume no liability. Changes of parts or materials shall be carried out at its own discretion.
The information referred to in this assembly guide accessories, radio gear and the drive are
only recommendations.
Instructions
Thank you for the purchase of this product and congratulations, you've chosen
a quality product made in Germany out of the house CNC Hager.
Please read these instructions carefully before construction and proceed with building step by step.
General Information:
The Impressivo a Funmodell in wood construction in conjunction
with carbon fiber. It boasts a radical new look, CNC machined parts and large range
of speeds which can be flown both slow and very fast without losing in kindliness and
safe handling.
The wing rib is created in design and equipped with high Carbon Pipes.
A double hull bottom to ensure a clean battery cables and a pleasant change.
The instructions in this rudder deflections are given a basic setting for the first flights.
This can also be easily adapted to its own fiscal habits.
Construction: ribs, sides, ribs and ridges are dovetailed with each other and thus make it
much easier to ensure the development of the model.
For sufficient stability at high speeds The large-sized Carbon Spars in the wings.
The test models were covered with Oracover.
Tested Drive and RC:
Motor : MEGA 16 / 15 / 3
Battery : 3S Kokam 2100mah 30C
Regulator : 40A
Prop : 4,7 x 4,7 CAM Speed
Receiver : Schulze Delta 535
Servo : Graupner DES 427 BB Digital