CMT ORANGE TOOLS CMT200, Operating/Safety Instructions Manual

Page: 5 / 38

5 Setting Up
1. With CMT200 placed
upside down on the
ground, loosen the
rear leg locking knob
(10) and slide the rear
leg from its storage
position.
Pivot the leg just clear of the front face. Slide
it all the way forward then lift and slide it fully
into its housing at the rear. Tighten the knob.
2. Raise the foot pedal
(5) until it “clicks” into
position.
3. Pivot the front legs (6)
out as far as they will
go then turn the front
leg locking knobs (9)
clockwise until the
rounded section of the
knob tightens onto the
leg housing, as shown.
Several turns may be necessary on initial
set-up until the clamps tighten into
place – a half turn is all that is required to
release the legs when folding.
4. Turn the CMT200
upright and recheck
that all legs are locked
firmly in position.
5. Rotate the moving jaw
locking tab (11) to the
horizontal position and
super jaws is now ready for use.
FOLDING
Folding is the reverse
procedure of above.
Ensure that:
• The lock / release
switch is in the “unlock
position”;
• The foot pedal locking
latch (8) is used to
release and fold the
foot pedal;
• The moving jaw locking
tab (11) is in the
“vertical” position to
prevent the jaw from
sliding out
• The rear leg is engaged
fully into its housing
and the rear leg locking
knob (10) is tightened
firmly.
When in its folded
position the rear leg
becomes a carrying
handle, to aid in
transportation.
SETTING UP