CMi 401140, Original Instructions Manual

Page: 25 / 56

25
– Set the required chopping depth by
adjusting the chopping spur (
►
Chop-
ping spur – p. 23).
– Starting the motor (
►
Starting the
engine – p. 24).
►
P. 5, item 7
– Activate turn-on lock (29).
– Pull the coupling handle (1) and hold.
Cleaning and maintenance
Cleaning and maintenance overview
Before each use
Every 50 operating hours or every six
months
Cleaning the device
– Wipe down the device with a damp cloth.
Cleaning the air filter
►
P. 3, item 2
– Stop the motor and remove the spark
plug connector.
– Remove air filter cover (10).
– Remove the air filter.
– Wash the air filter in warm water (with a
small amount of detergent).
– Rinse the air filter through with clean
water.
– Leave the air filter to dry out completely.
– Insert the new or cleaned air filter.
– Mount air filter cover (10) again.
Checking the level of motor oil
►
P. 5, item 8
NOTICE!
Risk of damage to the device!
Do not move the unit with a rotating
chopping tool over cement or asphalt
surfaces etc. Instead use the built-in
front support wheel and make sure
the motor is switched off.
DANGER!
Risk of injury!
Prior to conducting maintenance or
cleaning:
– Switch off the motor
– Allow the unit to cool down
– Removing the ignition cable
DANGER!
Risk of injury!
Carry out the maintenance work
described here in person.
All other work, in particular motor
maintenance and repair, must be
carried out by a trained specialist.
Improper maintenance work can
damage the device and lead to inju-
ries.
What? How?
Clean the air filter
►
Cleaning the air fil-
ter – p. 25
Check the starter
cord for damages
to the cord Visual check.
Check the level of
motor oil
►
Checking the level of
motor oil – p. 25
Check screw
connections for
tight fit Use a suitable tool to
tighten the screw con-
nections by hand.
What? How?
Clean/replace
spark plugs
►
Cleaning/replacing
spark plugs – p. 26
Change motor oil
►
Filling with motor
oil – p. 23
NOTICE!
Risk of damage to the device!
The device should never be operated
without an air filter, as this may cause
damage to the engine.
If the air filter is damaged or heavily
soiled, it must be replaced.
NOTICE!
Risk of damage to the device!
Never brush off a soiled air filter.
Brushing will drive the dirt into the
fibres of the air filter.
What? How?
GB
Motorhacke_401140.book Seite 25 Freitag, 18. Oktober 2013 8:30 08