CMi 401 133, Original Instructions Manual

Page: 50 / 162

50
Assembly
Assembling the saw rail and saw chain
►
P. 3, item 3
– Loosen the nut (6) on the chain wheel
guard (7) and remove chain wheel guard.
►
P. 3, item 4
– Turn the screw (14), to move the bolt (15)
towards the back.
►
P. 4, item 5
– Place Saw rail (5) on the guide rail (17)
with the guide groove (16).
– Place the saw chain (4) around the chain
wheel (18). Heed the assembly direction.
– Place the saw chain (4) around the saw
rail (5).
►
P. 4, item 6
– Attach the chain wheel guard (7).
– Tighten the fastening nut (6) only slightly.
Tensioning the saw chain
►
P. 4, item 7
– Tighten the tension screw (14) until the
chain lies on the underside of the saw rail.
– Tighten the fastening nut (6).
Letting the saw chain run in
During the run-in time, re-tension the saw
chain and rail after a maximum of 5 cuts.
Checking the tensioning of the saw
chain
The saw chain is tensioned correctly if it lies
close against the underside of the saw rail
and can be moved easily by hand.
Readjust tension of the saw chain when nec-
essary (
►
Re-tensioning the saw chain –
p. 54).
Checking the chain lubrication
The device may not be used without suffi-
cient chain lubrication. Insufficient lubrica-
tion reduces the service life of the device.
– Check the oil quantity in the tank.
– Start the device.
– Hold the running saw chain approx.
15 cm over a suitable surface for a time
(15 s).
If there is sufficient chain lubrication, the oil
spraying off of the saw chain will form a slight
trail.
Checking the chain brake
The chain brake ensures immediate blocking
of the saw chain in case of a kickback.
Before beginning work with the device, it
must be checked to ensure that it is function-
ing correctly.
– Set device on the ground.
– Start the device.
– Tip the hand guard forwards. The chain
must stop immediately.
– If the chain brake is not working correctly,
contact a service partner immediately.
Filling up saw chain oil
►
P. 4, item 8
DANGER! Risk of injury during
operation!
Improperly mounted
parts can cause severe and even
fatal injuries when using the device!
This device may only be commis-
sioned if all parts are mounted com-
pletely and tightly and no part is
damaged!
• Therefore, read the whole chap-
ter before you assemble the
parts!
• Assemble the parts carefully and
completely.
• Use tools when their use is sug-
gested.
DANGER! Risk of injury during
assembly!
Pull out the power plug
before conducting any work on the
device.
DANGER! Risk of injuries due to
cuts!
The teeth of the saw chain are
very sharp! Protective gloves must
be worn for all work on the chain.
DANGER! Risk of injury!
An
improperly mounted saw chain
causes uncontrolled cutting behav-
iour of the device! When assembling
the chain, heed the prescribed run-
ning direction!
Note:
When attaching the chain,
heed the correct position of the guide
groove (saw rail).
NOTICE! Environmental damage!
Since the saw chain oil can penetrate
the environment during operation,
biologically-degradable special veg-
etable-based saw chain oils should
be used.
GB
Kettensaege_Elektro_401133.book Seite 50 Montag, 19. Oktober 2015 5:17 17