
pair of the WIDI-X8 use one channel, up to 32 pairs of WIDI-X8 can work at the
same time.
The default system radio channel is already set. If necessary, you can set the radio
channel again (you need to remove the battery cover).
You can set the frequency automatically or manually, plus, you can also use the
one-to-multi function (automatically finding and switching).
Terms
:
the selectors set to ON is defined as position “1”, and another position is
defined as position “0”, see below:
ON DIP
Manually setting the radio frequency
Set the DIP 2 to position 0 for manual frequency setting mode, then use DIP3-8 to set
the frequency, refer to the appendix for the specific radio channel.
Important:
To make the WIDI system work properly, make sure each pair of the WIDI-X8s are
using the same radio channel, and different pairs must not use the same radio
channel.
The WIDI system supports up to 32 pairs of WIDI-X8 used at the same place. If
you use many pairs of WIDI-X8s at the same place, please set the radio channels
within 1-32, that is, DIP3 is always set to position “0”.
Automatically setting the radio frequency
Set the DIP 2 to position 1 for automatic frequency setting mode. In this mode, DIP 3-8
are disabled. When you switch on the WIDI-X8, it will automatically find a free radio
channel and establish communication, and the green indicator will on to show the
communication is established.
To change the radio channel, please press and hold the frequency set button of any
WIDI-X8 of the pair for about 3 seconds, the it will search a free radio channel again. When
it find a available channel, it will told another WIDI-X8 to set to the same radio channel, and
both signal indicators are on. If you cannot make the two signal indicators on, please
repeat the above steps until the two signal indicators are on.
To disable the frequency set button, please set the power switch to “LOCK”.
Important:
To properly use the automatic frequency setting function, please switch on the
two WIDI-X8s in the same pairs one by one. If you cannot achieve the
communication, please restart any one of the two WIDI-X8s, or use the finding and
switching function to establish the communication.
Position 1
Position 0
1 2 3 4 5 6 7 8
13