CMA Dishmachines EST-44, Service And Parts Manual

Page: 14 / 55

Getting Started
MODEL EST-44 Service and Parts Manual Rev. 2 .08A
Page
12
2.2.7. Table Limit Switch Installation
The Model EST-44 is shipped with a Table Limit Switch fully wired and connected in the main
control box, ready to be installed on the clean side of the dishtable. The Table Limit Switch
MUST be installed to prevent dishrack and Conveyor Drive damage.
1.
Remove the template that was shipped to hold the table-limit switch assembly
together
.
2.
Remove the activator bar (Figure 2.2.7a).
3. Position the template in the middle of the clean side of the dishtable.
4.
Mark the end of the table, where the holes need to be drilled (Figure 2.2.7b)
.
5.
Drill the holes
.
6. Attach the Table Limit Switch, using the hardware supplied .
7. Reattach the activator bar removed earlier.
8. Test that it functions properly (Figure 2.2.7c).
Figure 2.2.7a Figure 2.2.7b
Note: This terminal is not actual size ,not to be used
for installation!
Figure 2.2.7c