Club Car IQ PLUS SYSTEM, Maintenance Service Supplement

Page: 148 / 156

IQ PLUS SYSTEM DISPLAY MODULE (IQDM-P SERIES 2) PROGRAMMING Functions Menu
Page 18-6 2006 IQ Plus System Electric Vehicle Maintenance and Service Supplement
18
10. With the controller settings stored in the memory of the handset, the handset can be used to transfer all
of the desired speed controller settings to any IQ Plus System vehicle or group of IQ Plus System vehi-
cles.
See Speed Controller Cloning – Transferring Settings from the Handset to the Vehicle on
page 18-6.
WRITE SETTINGS TO CONTROLLER
This function transfers all of the speed controller settings from the handset to the vehicle speed controller.
This enables the trained technician to “clone” a speed controller. Once the speed controller settings have
been transferred to the handset, the technician can then connect the handset to another vehicle and transfer
the stored settings into the speed controller.
Speed Controller Cloning – Transferring Settings from the Handset to the Vehicle
1. Perform this procedure with a handset that has the desired speed controller settings. See Speed Con-
troller Cloning – Transferring Settings from the Vehicle to the Handset on page 18-5.
2. Locate a vehicle that does not have the desired speed controller settings.
3. Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position,
and lock the park brake.
4. Plug the handset into the vehicle.
4.1. Connect one end of the cable to the jack located on the bottom of the handset.
4.2. Connect the cable adaptor to the IQDM-P Series 2 cable.
4.3. Find the IQDM jack located below the Forward/Reverse switch.
4.4. Remove the dust cap from the IQDM jack located on the vehicle below the Forward/Reverse
switch.
4.5. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack .
5. Scroll to the functions menu and select.
6. Select settings .
7. Select write settings to controller .
8. Press + on the change value button to confirm the operation.
9. The handset will display an “executing...” message for the next few seconds while the controller settings
are being stored in the handset’s memory.
10. When the handset is finished transferring the speed controller settings, a confirmation message is dis-
played.
11. Repeat this procedure for additional vehicles that need to be programmed with the same handset set-
tings.