Club Car IQ PLUS 2008, Maintenance And Service Manual Supplement

Page: 123 / 164

MOTOR (MODEL DA5-4006) Motor
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 16-3
16
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the
shock absorber (pushing upwards) to move it out of the way (Figure 16-3, Page 16-3) .
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed,
remove the jack from beneath the transaxle and allow the springs to rest on the floor (Figure 16-3,
Page 16-3) .
9. Remove the four bolts that mount the motor to the transaxle (Figure 16-20, Page 16-15). See following
CAUTION.
ý
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft in step 9.
Fingers may get pinched when motor disengages.
10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and
remove the motor from the vehicle.
Figure 16-1 Lift Vehicle with Floor Jack Figure 16-2 Vehicle Supported on Jack Stands
Figure 16-3 Lower Axle