![background image](http://html1.mh-extra.com/html/club-car/iq-plus-2008/iq-plus-2008_maintenance-and-service-manual-supplement_2626727088.webp)
ELECTRICAL COMPONENTS
Tow/Run Switch
Page 13-4
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
13
TOW/RUN SWITCH
See General Warning, Section 10, Page 10-1.
Testing the Tow/Run Switch
See Test Procedure 6, Section 11, Page 11-21.
Tow/Run Switch Removal
1. Disconnect the batteries and discharge the controller.
See Disconnecting The Batteries on page 10-3.
2. Remove Tow/Run switch boot/hex nut (6)
3. Remove Tow/Run switch (10) and nut (9) from bracket (5).
4. Disconnect the two-pin connector (7) and remove switch.
Tow/Run Switch Installation
1. Installation is reverse of removal. Make sure groove on switch is aligned with tang on bracket. Tighten
Tow/Run switch boot/hex nut (6) to 16 in-lb (1.8 N·m)
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
Figure 13-3 Tow/Run Switch and Forward/Reverse Rocker Switch
11
13
5
10
7
6
9