ELECTRICAL COMPONENTS
Ferrite Beads – CE Mark vehicles
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
Page 13-17
13
Ferrite Beads – Villager 8 IQ Plus Vehicle
NOTE:
If a Villager 8 being serviced or repaired is found to have beads in an arrangement other than what
is shown in this manual, relocate the beads to these updated locations.
To remove either type of ferrite bead, cut the wire tie and release the two tabs on the side of the ferrite bead
to open and remove from wire or wires.
To install either type of ferrite bead, release the two tabs on the side of the ferrite bead to open and place onto
wire or wires. Close the ferrite bead and press the tabs until they snap closed. Secure with wire tie.
Figure 13-1 Ferrite Bead Locations (Controller, OBC and Solenoid) – Villager 8
1. TDK beads
Figure 14 Ferrite Bead Locations (Motor) – Villager 8
1. TDK bead - loop blue and orange wires to pass through bead
twice
2. Fair-Rite beads
1
1
1
1
1
B
+
B
-
M
-
F
2
F1
2
1
2
