Cleaning the Vehicle
NOTE:
Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles to be
stored for extended periods should be prepared for storage as instructed.
See Preparing the Gasoline
Vehicle for Extended Storage on page 33.
1
3
2
1. Fuel Cap, 2. Fuel Hose, 3. Vent
2890
Figure 35
Fuel Tank
1.
Lift and remove the driver seat bottom.
2.
The fuel tank is located on passenger side of vehicle
(Figure 35)
. Remove fuel cap and fill the fuel tank with fresh
unleaded gasoline only.
See preceding CAUTION and NOTE
.
3.
Replace fuel cap on tank. Ensure cap is securely tightened (tighten until it clicks).
4.
Replace seat bottom.
CLEANING THE VEHICLE
These vehicles are equipped with Acrylonitrile Butadiene Styrene (ABS) front bodies and Thermoplastic PolyOlefin
(TPO) for rear bodies. Use only commercially available automotive cleaners with a sponge or soft cloth for normal
cleaning. A garden hose at normal residential water pressure is adequate.
Club Car does not recommend any type of pressure washing or steam cleaning. Such a process (especially if the
vehicle has the rear body removed) will expose electrical components to moisture. Moisture entering electrical
components can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should be
removed immediately to prevent possible stains.
The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm water applied
with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult stains or scratches,
blemishes, or other body damage, see the appropriate Maintenance and Service Manual or contact your local Club
Car dealer.
See following NOTE.
NOTE:
Dispose of waste water properly.
Carryall 100 CE Mark Owner’s Manual
Page 55