E
N
G
L
I
S
H
8
TESTING THE
BATTERY
After fully charging the battery so all red
lights come on, apply a 100 amp load to
the vehicle charging plug (on the
portable power source), for a period of 6
seconds, while monitoring the battery
voltage (at the vehicle charging plug).
The battery is good if the voltage is 9
Vdc or higher.
BATTERY REMOVAL
AND DISPOSAL
INSTRUCTIONS
Contains sealed, non-
spillable lead acid battery.
Must be disposed of
properly.
!!! IMPORTANT !!!
REMOVAL AND DISPOSAL
The battery inside this portable power
source is a sealed lead-acid battery.
By LAW, it is required to be removed
and recycled or disposed of properly.
While there are federal regulations that
must be complied with throughout the
United States, your individual state or
local governments may have additional
regulations to be followed.
When the battery in this product is in
need of replacement, remove it
according to the instructions provided
below and take it to your local recycling
center for proper recycling or disposal.
If you don’t have a local recycling center
that handles sealed lead-acid batteries,
contact your local environmental agency
for instructions.
REMOVAL INSTRUCTIONS
Begin by making sure that both booster
clamps are securely stowed in their
holsters on each side of the portable
power source.
1.
Lay the portable power source
down on its front. On the back of
the unit, locate the four screws that
hold the portable power source
enclosure together (TWO ALONG
THE LEFT EDGE AND TWO
ALONG THE RIGHT EDGE).
2.
Remove the four screws, then lift off
the back half of the portable power
source enclosure.
3.
On the top of the battery are two
terminals, each with wires
connected to them. Disconnect
these wires from the battery by
removing the bolts that hold them to
the battery terminals. TO
PREVENT ACCIDENTAL ARCING,
be careful not to touch both battery
terminals with the tools being used
to remove the bolts.
4.
Lift the battery out of the front half
of the enclosure.
5.
To install a new battery, reverse the
above procedure.
Note:
Remember that the red wires
connect to the positive (+)
battery terminal and the black
wires connect to the negative
(–) battery terminal.
Pb
842-270-000 Portable Power Source En, Sp, Fr, Pg, Du.p65
3/12/01, 10:14 AM
8
