13
1. Start The Drill At 45
°
To The Work Surface With
The Bit About 1/2” From The Work Surface. The
Drill Must Be Running At Full Speed Before The
Bit Comes In Contact With The Work Piece
2. Slowly Lower The Bit Into The Work Piece Until
The Drill Bit Has Cut About 1/4” In To The Wok
Piece
3. Slowly Bring The Drill Perpendicular To The
Work Piece (Slide Friction Due To Drilling At An
Angle Will Cause The HD Hand Held Drill Unit To
Vibrate And Possibly Shut The Drill Unit Off)
Let The Drill Do All Of The Work
DO NOT
FORCE THE DRILL INTO THE WORK
PIECE!!!!
4. Remove The Core From The Hole About Every
2” To 3”
Do Not Stop The Drill Until It Is Out Of The Hole
5. When Restarting The Hand Held Drill Bring The
Drill Up To Full Speed With The Bit About 1/2”
From The Bottom Of The Hole And
Perpendicular With The Hole. Slowly Lower The
Drill Unit It Comes In Contact With The Work
Piece
Repeat Steps 4 and 5 Until The Job Is Completed
