10
•
For Additional Safety Use A Ground Fault-Interrupter (GFCI ) Device.
•
Do Not Use The Drill In Inflammable, Gaseous, Or Explosive Atmosphere
•
Do Not Expose The Drill Motor To Rain Or Use In Damp Or Wet Locations
•
Do Not Abuse The Cord, Or Carry Or Lift The Motor By The Cord
•
Keep The Power Supply Cord Away From Humidity And Water
•
Make Sure That The ON/OFF Switch Is In The “OFF” Position Before Plugging
Into A Power Supply
•
Unplug The Drill Before Changing A Drill Bit
•
Unplug The Power Cord When Attaching The Water Supply, Also Turn The
Water Valve To The “Off” Position Before Attaching
•
Do Not Use If Parts Of The Motor Housing Are Missing Or Damaged
•
Do Not Use If The Power Cable Or Extension Cable Is Damaged
•
Do Not Make Any Attachments, Adjustments, Or Accessory Changes With The
Unit Plugged In
•
Always Use The Proper Length/AWG For Extension Cords (See The Section
Titled Electrical Supply)
♦
If Water Comes Out Of The Over Flow Bore (Item 3) Stop The Drill Operation
And Replace The Water Ring Seal Immediately
♦
DO NOT Use Or Reuse Waste Water. Dirt And Slurry May Damage The Ring
Seals
•
Prevent Water From Spraying On Any Part Of The Electrical Motor Or Cables
II. OPERATION
A. Core Bit Installation
Adapters are needed to install specific sized core bits.
1. Using a wrench to firmly hold the output shaft, screw the core bit onto the
spindle until snug.
