Clinton AS-895E, Service Manual

Page: 4 / 23

INSTALLATION
A. CONTROL BOX TO MOTOR
Refer to the control box assembly parts drawing in page 6-4. Attach the mounting brackets to
the control box then, mount the control box to the motor with the hardwareprovided.
B. MOTOR
1. Drill three holes in the sewing machine table as shown in figure 2-1.
2. Mount the motor to the table using the spacers, carriage bolts, nuts, washers, and flanged
spacers supplied (See page 6-2). Install pulley and belt then check the following:
a. The motor is mounted so that the motor drive pulley and sewing machine drive pulley are
properly aligned.
b. The V-belt connecting the motor to the sewing machine should be tensioned properly. It
should be possible to pull a correctly tensioned belt together between two fingers within
approximately 2 cm (3/4"). Excessive tension may not only shorten the life of the bear-
ings, but could also affect the operation of the sewing machine. A loose belt will affect
positioning accuracy.
c. Install the belt guard.
2-1
ML895E-17
SECTION II
®
MOTOR INSTALLATION
FIG. 2-1