Clinton AS-895E, Service Manual

Page: 10 / 23

®
ML895E-23
C. HIDDEN PARAMETERS
The parameters in this section are separated from the Direct Access parameters because they are
infrequently changed and should not be changed by the operator. The parameters are listed in
TABLE 4-2
To enable access to Hidden Parameters, follow the sequence described below.
1. Turn power off, if it is on, then wait until the display goes blank.
2. Press the key and the key simultaneously. Keep pressed then,
3. Turn power on. A series of "***" will appear on the display. They will slowly dissapear.
4. Release the keys then press the key before all the stars dissapear.
5. Press the key repeatedly, until the first hidden parameter group (****SPEEDS) is dis
played. Note that 4 stars (*) as described in section "A".
6. Parameters may then be changed by following the procedure described under DIRECT
ACCESS PARAMETERS (Page 5-1).
D. MASTER RESET
In some cases it may be necessary to reset all parameters to their default values. This is done as
follows:
1. Turn power off, if it is on, then wait until the display goes blank.
2. Press the key, key and key simultaneously. Keep pressed then,
3. Turn power on. The display alternates between "Push Set" and "For Reset".
4. Push the key within 10 cycles.
5. The word "Programming" is displayed. The parameters will be reset to their default values after
a few seconds.
4-3
PARAMETER DESCRIPTION DEFAULT RANGE
****SPEEDS
RPM RPM
MAXIMUM Maximum sewing machine speed. The speed
cannot go higher than 3500 times the pulley
ratio. 4200 1000-9900
****TOGGLE SWITCHES
DIRECTION
AUTO MODE
STACKER Direction of motor rotation viewed from pulley.
Maximum speed until eye is uncovered.
Stacker operates after EOC or alternate EOC CCW
DISABLE
FIX
CCW/CW
ENABLE/DISABLE
FIX/FLEX