CM2026
Home Weather Station
Sensor Assembly
Before mounting the station at your chosen location, it’s worth setting up the
weather station properly so that all functions can be tested prior to installation. If
there are any problems during the assembly of the sensors, it may not be so easy
to access the system later on.
The ClimeMET CM2026 uses a mast that will already have the majority of the
sensors installed – the thermo-hygro transmitter, rain collector and wind direction
sensor will already be attached. The only sensor that needs to be connected is
the set of wind cups.
Attaching the Wind Cups:
1. Push the wind cups firmly onto the steel shaft at the bottom of the anemometer
unit, directly underneath the wind vane. Look closely at the shape of the shaft to
be sure the cups are being attached securely.
2. Using the Allen Key supplied, tighten the set screw on the side of the wind cups.
3. Spin the wind cups in order to test they are connected correctly. If the wind
cups rotate freely and do not ‘stick’, the anemometer is ready for installation.
08
Tighten set screw
using Allen Key
Push cups onto steel shaft
