CM2026
Home Weather Station
Reset to Factory Defaults
If you need to reset all settings back to their factory defaults, press and hold the
+
key for 20 seconds. This will clear all settings, remove all records and erase any
stored data, so make sure this is exactly what is desired before using this function.
Maintenance & Troubleshooting
The ClimeMET CM2026 has been designed with dependability in mind and will
require minimal attention once set up. After the system has been installed, you
should find that the only maintenance required will be an occasional check and
clean of the sensors in order to ensure they provide you with years of service. This
weather station uses 2 x AA batteries to power the outdoor sensor-suite - it will
depend on the quality of the batteries used, but we’d normally expect these to last
for around 12 months. At the same time you access the station to change the
batteries, you may want to clean the sensors and carry out some brief checks.
If it appears that any problems are occurring with your weather station, please see
the below guide for further information:
Display Console:
Outdoor data is not displaying and dashes are shown instead
Ensure that the outdoor sensor suite is within range of the display console – the
maximum range is 100 metres, or just over 300 feet. Please note that obstacles
such as trees/walls/etc will have an impact on this communication range, so try to
make sure the line of sight is as clear as possible.
Check that the batteries inside the sensor suite are not depleted – insert new
batteries if you cannot be sure.
16
