Climax CTC-1052-QT-DT35A, User Manual

Page: 13 / 55

9

Commands ( 20-24 ) are used to program
the Alarm reporting method for each Tel.
Number.

Command ( 20 ): Program the same Alarm
Reporting Method for all 4 Tel. Numbers.

Command ( 21-24 ): Program the alarm
reporting method for the 1
st
-
4
th
Tel.
Numbers respectively.

Available Options:
<NOTE>

The latest Command ( 20-24 ) setting(s)
will overwrite any previously entered
setting(s).

If Speech Method is selected:
After the dialing for alarm/emergency
trigger is successful, CTC-1052-QT-
DT35A opens a two-way voice
communication between the Call
Recipient and CTC-1052-QT-DT35A for
1-10 minutes (set by Command #46).
If the Call Recipient needs more talk
time, they can press any keys except 9
or 0 on their phone set to reset to the
original communication duration (set by
Command #46).
To terminate the call, press ( 9) or
RESET BUTTON on CTC-1052-QT-
DT35A.
During the Speech period, CTC-1052-
QT-DT35A will emit two beeps via the
telephone handset to alert the call
recipient the remaining time of 20 & 10
secs.

Speech Reporting made under Silent
Mode (set by Command #35) will
automatically be switched to Listen-in,
but call recipient can press DTMF keys
to open two-way communication or
change modes.

If any of SMS Reporting Methods is
selected:
Once alarm or emergency data is
successfully transmitted, the CTC-
1052-QT-DT35A will automatically send
out a SMS (CID) Message.
Command 31
Ringer Enable for Incoming Calls

CTC-1052-QT-DT35A can be programmed
to emit a ring tone as an audio alert, or
silent for incoming calls.
Function Selection Result
(0) OFF
(Ring Tone Disable)
(1)
ON
(Ring Tone Enable)

Factory Default is set as ( 0 ), OFF .

If the function is set to ON , you can answer
the incoming call by pressing the Active
button of WTR, PB, or Fall Sensor, or the
Help Button on CTC-1052-QT-DT35A.

The time-out period for the incoming call is
30 minutes.

To terminate the incoming call, either press
the
Active button of WTR, PB, or Fall
Sensor, or press the Reset Button on
CTC-1052-QT-DT35A.

During the AC Power failure period, Ring
Tone is automatically disabled.
Command 32
Audible Fault Alert

CTC-1052-QT-DT35A can be programmed
to emit Fault Alert Beeps
every 30
seconds from AC Failure.
Function Selection Result
(0)
OFF
(No Warning Beep)
(1)
ON
(With Warning Beep)

Factory Default is set as ( 0 ), OFF .
Command 34
Method
Function
Selection
Speech
Method
(3)
Open Two-way
communication
SMS
Reporting
Method
(4) SMS (CID)