Climax BF-R, Operating Manual

Page: 33 / 68

P/N 102823, Rev. 0 Page 21
2. Insert the collet rod through the centershaft from the rear of the tool.
3. Thread the collet onto the draw rod until it touches the end of the center
shaft.
4. Insert the cotter pin into the draw rod end and open the ends. This assures
that the collet will not be threaded off of the end of the rod.
3.2.2 Assembling the wedge set
Do the following to assemble the wedge set:
1. Assemble the wedge sets by laying them on the flat side with the wedge
guide grooves at the same ends.
2. Place the springs through the holes and connect the spring ends to form a
circle.
3. Once both springs are properly connected, slide the assembly over the rod
and hook the guide grooves into the cone slots.
4. Insert the rod into the center shaft from the front.
5. Thread on the draw nut/wrench assembly until it contacts the centershaft.
The wedge ends are then aligned with the slots in the centershaft.
6. Thread the self-locking nut onto the rod until it is flush with the rod end.