Tranquility
®
D i g i t a l ( D X M 2 ) — Tr o u b l e s h o o t i n g G u i d e
R e v. : 1 0 M a r c h , 2 0 1 5
68
G e o t h e r m a l H e a t i n g a n d C o o l i n g
ATC32U02 Thermostat Screens and Set Up
9.4.2 Flow Conditions
Displays detailed blower and pump speed / valve
position readings that were recorded at the time the
fault occurred.
NOTE
: If multiple units are connected to one thermostat, refer
to section 9.7.
9.4.3 Input/Output Conditions
Displays the status of all physical and communicated
inputs, switches, and control outputs that were
recorded at the time the fault occurred.
NOTE
: If multiple units are connected to one thermostat, refer
to section 9.7.
9.4.4 Configuration Conditions
Displays the status of all dipswitch settings that were
recorded at the time the fault occurred.
NOTE
: If multiple units are connected to one thermostat, refer
to section 9.7.
9.4.5 Possible Causes
Possible causes as to why the fault occurred
NOTE
: If multiple units are connected to one thermostat, refer
to section 9.7.
9.5
CLEAR FAULT HISTORY
Clear Fault History will clear all fault codes stored in the
thermostat as well as the fault history in any connected
communicating controls (DXM2/AXM).
FAULT FLOW CONDITIONS
LT1 LOW WATER TEMP
HEAT 1 11:11 AM 11/14
ECM TARGET CFM 800
ECM BLOWER RPM 550
FLOW RATE GPM 6.5
PUMP SPEED 60%
PUMP WATTS 140
LOOP CONFIG VS PUMP
PREVIOUS SINGLE
FAULT I / O CONDITIONS
LT1 LOW WATER TEMP
HEAT 1 11:11 AM 11/14
TSTAT SAFETY OUTPT
CONV COMM
HPS
Y1
Y1
LOC
CC
Y2
Y2
CO
RV
W
W
ACC1
O
O
OUTPT
ACC2
G
G
FAN
AL1
H
H
HWG
EH1
OVR
DH
PUMP
EH2
PREVIOUS
FAULT CONFG CONDITIONS
LT1 LOW WATER TEMP
HEAT 1 11:11 AM 11/14
S1 S2 S3
1 ON 1 ON 1 ON
2 ON 2 ON 2 OFF
3 ON 3 ON 3 OFF
4 ON 4 ON 4 OFF
5 ON 5 ON
6 ON 6 ON LT1 WELL
7 ON 7 ON LT2 WELL
8 ON 8 ON
PREVIOUS
POSSIBLE FAULT CAUSES
LOW WATER COIL TEMP
LOW WATER TEMP - HTG
LOW WATER FLOW - HTG
LOW REFRIG CHARGE - HTG
INCORRECT LT1 SETTING
BAD LT1 THERMISTOR
PREVIOUS
