Page 4
!
Figure 1 - LCU Installation
Location and Access
Large Commercial Units are typically installed in a floor
level closet or in a small mechanical room. Refer to
Figure 1 for an illustration of a typical installation. Install
units with adequate clearance to allow maintenance and
servicing. Conform to the following guidelines when
selecting unit location:
1.
Provide adequate clearance for filter replacement
and drain pan cleaning. DO NOT block filter access
with piping, conduit or other materials. Refer to
submittal drawing for Vertical Unit Dimensions.
INSTALLATION
Installation of Supply and Return Piping
Follow these piping guidelines:
Piping must comply with ALL applicable Codes.
1.
Install a drain valve at the base of each supply and
return riser to facilitate system flushing.
2.
Install shut-off/balancing valves and unions at each
unit to permit unit removal for servicing.
2.
Provide access for fan and fan motor maintenance
and for servicing of the compressor and coils without
removal of the unit.
3.
Provide an unobstructed path to the unit within the
closet or mechanical room to enable removal of the
unit if necessary.
4.
Provide access to water valves and fittings, and
screwdriver access to the unit side panels, discharge
collar and all electrical connections
The installation of Large Commercial Water Source
Heat Pump Units and all associated components, parts
and accessories that make up the installation shall be in
accordance with the regulations of ALL Authorities
having jurisdiction and MUST conform to ALL
applicable Codes. It is the responsibility of the Installing
Contractor to determine and comply with ALL
applicable Codes and Regulations.
T
Optional Discharge
Supply Air
Optional Discharge
Access
Panel
Access
Panel
Access
Panel
Access
Panel
Vibration
Pad
Control Box
Supply Air
Supply Water
Return
Water
Balancing
Valve
Valves
Trap
Condensate
24 V Remote
Mtd. Stat
Power
Supply
Disconnect
Switch or
Per Local Codes
Condensate
Water In
Water Out
Unions
Rear Return Front Blow shown
Refer to Product Engineering Catalog
for other arrangements & dimensions
CAUTION
