31
To make up the A-frame, you will need two curved glazing bars (V943) and two
curved T shape bars (961).
As per DIAGRAM A & C & D & E, firstly insert six 15mm bolts (a8) into the channel
on the back of curved glazing bar (V943). Place these bolts with the holes on
curved T shape bar (961) and tighten the nuts slightly.
Please Note: The end of part #A943 should extend 15 mm against the end of
part #961 on bottom.
Repeat on the other side.
DIAGRAM A & A-1
Loose top bolt (a8) on V943 & 961. Place the ridge extension plate (069)
and end hole of ridge onto the bolt and lightly tighten the nut. Repeat on the
other side.
Now place connecting plate (m1) into position, use 10mm bolts (a1)
to tighten the nuts slightly.
DIAGRAM B & B-1
The A-frame brace (962) can now be fixed to the curved T shape bar (961)
using 10mm bolts (a1).
DIAGRAM C
Loose the third bolt (a8) on A943 & 961 as per Diagram, then connect up- per side
rail of main house in the position and tighten the nuts slightly
Repeat on the other side.
DIAGRAM D
Loose the forth bolt (a8) on V943 & 961 as per Diagram, then connect mid- dle side rail
of main house in the position and tighten the nuts slightly
Repeat on the other side.
DIAGRAM E
Loose the sixth bolt (a8) on V943 as per Diagram, then connect bottom sill of main
house and anchor leg in the position and tighten the nuts slightly. Repeat on the other
side.
Check that the ridge is level and straight, and that the sides are vertical.
After, tighten all the bolts.
Assemble the A-frame
