Table of Installer-Programmable Features: 1 beep = OFF, 2 beeps = ON
Feature
Select
Right x 1
Right x 2
Right x 3
Left x
1
Single
/Double
Lock Pulse
(
1 beep
/2 beeps)
NOT USED
Door Ajar Warning
/Delayed Courtesy Lights
(
1 beep
/2 beeps)
Left x
2
Single
/Double Unlock Pulse
(
1 beep
/2 beeps)
NOT USED
Accessory Output A
Trunk Interlock
(
On
/Off)
Left x
3
Lock/Unlock Pulse:
1 second/
3 second
(
1 beep
/2 beeps)
NOT USED
Accessory Output A for
2-Stage Unlocking
(pgs 5 & 9-10) (On/
Off
)
Left x
4
Positive
/Negative
Door Lock Polarity
(1 beep/
2 beeps
)
IntelliStart 4: Diesel/
Gas
(1 beep/
2 beeps
)
NOT USED
Left x
5
IntelliStart 4: Program RPM
NOTE A
Program Optional
SmartWindows 4
NOTE B
NOT USED
Left x
6
Car Horn
/Optional Siren
(
1 beep
/2 beeps)
Sleep Mode (only if in
dealer mode, see page 3)
(On/
Off
)
Positive/
Negative
Door Trigger Polarity (1
beep/2 beeps)
n
NOTE A: Please note that the Diesel/Gas selection (column 2, row 4) must be made before
programming RPM. To program RPM, the engine must be running at its normal idle speed when
you select this feature. Two beeps and two parking light flashes confirm RPM programming, two
beeps and one parking light flash indicates no tach signal, check the BLACK/GRAY wire
connection.
n
NOTE B: You will hear two beeps. Press and hold the drivers window switch in the up position for
2 seconds, then release. The windows will close and open repeatedly. Programming is complete
when the windows vent. For a second SmartWindows 4 module, briefly tap the drivers window
switch up to repeat the process for the rear windows.
System Checklist & Troubleshooting
The following checklist will assure that you have installed the Level FOUR correctly. Each
successive step requires that the previous step has been completed as indicated.
NOTE: If you are still having trouble after performing the following steps,
please call Clifford Technical Support Services at 1-800-444-4667.
Step 1: Test the immobilization circuit.
Arm the system by pressing the LOCK button on the Dealer Master remote (note: there are
no arm/disarm beep confirmations in Dealer Mode [see page 3]) from inside the vehicle and
wait 10 seconds. Turn the ignition to the “START” position.
n
Engine does not respond. This is the correct response, proceed to step 2.
n
4 beeps: If 4 beeps immediately or 5-10 seconds after arming, a trigger or sensor is open or active,
or the vehicle has delayed courtesy lights and the Delayed Courtesy Lights feature has not been
programmed on. Disarm and use the Eight-Event TotalRecall feature noted on page 7 to identify
the open/active input. If the door trigger is indicated, activate the delayed courtesy lights feature.
n
Engine starts or cranks. The starter or ignition connection is miswired. Retest the vehicle wires as
noted in the Starter Connection section on page 3.
n
Make sure the fuses are in the fuseholders and check the power and ground connections.
n
Verify the control unit connectors are properly inserted into the control unit.
n
Verify the ignition wire is connected to the true ignition line instead of a +12V line.
NOTE: If the 20-amp fuse blows upon arming:
10
