11
AFTER SALES SUPPORT
(AU) 1300 886 649 (NZ) 0800 836 761 | [email protected]
Getting Started (Cont.)
Assembling the grilles and blade
9 Remove the four screws and
washers as identified.
IMPORTANT:
Do not remove any
other screw! Only use a hand
screwdriver.
10 Fit the back safety grille into position
and refit the four screws and
washers, and tighten.
NOTE: Ensure the small hole located
in the edge of the grille is at the
bottom.
11 Rotate the motor spindle until the
flat surface is facing up.
12 Slide and push the fan blade onto
the spindle. Push it until the end of
the fan blade hole is aligned with the
end of the spindle.
Then fix and tighten the screw.
NOTE: Ensure the screw is lined up
with the flat surface.
13 Open all the side locking clips of the
front grille.
13
