WWW.CLF-LIGHTING.COM
10
Setup
Warning! Read “Safety Information” before installing, powering or operating the fixture.
Control panel and menu navigation
The
onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure individual fixture settings
(personality), read out data and execute service utilities. See “Onboard control menus” for a complete list of menus and commands.
Using the control buttons
•
To enter the menu select [MODE].
•
Press [UP] and [DOWN] to scroll within a menu or adjust values.
•
To enter a menu, select a function or apply a selection, press [ENTER].
•
To escape a function or move back one level in the menu structure, press [MODE].
•
Hold [MENU] = highlight for 15 seconds
•
Press [UP] and [DOWN] together to rotate display
DMX address setting
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller. For independent
control, each fixture must be assigned its to a separate channel. The DMX address can be configuredas by using the DMX ADDRESS
menu in the control panel. For setting the DMX address press [ENTER] before you can change the address.
•
The main screen will show a ‘dot’ and the backlight will be switched off when a DMX signal is detected.
•
The
fixture is fully RDM ready. So when you are using a RDM ready console you can address the unit and read out its complete
status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard
W-DMX control
Go to the W-DMX section in the main menu, press the button “UP” to switch off Wireless DMX or disconnect with all connected
Transmitters.
Pr
ess the button “DOWN’ to set the unit in the ”ready to connect with all not connected transmitters’ mode. If you press the mode button
on the Wireless sollution transmitter all the units in this mode will be connected.
If the unit is successfully connected in the home display the sign “ : V ” appears. If the unit is not connected to a transmitter in the home
display the sign “
: X ”. If the unit is switched off in the home display the sign “ : OFF ”.
•
Holding the
MENU
and
ENTER
button for more than 3 seconds, the wireless board will reset.
•
Do not use Wireless DMX and Wired DMX at the same time because it will give unwanted interference
