Cleveland Motion Controls Cleveland-Kidder TMI, Instruction Manual, Page: 11 / 18

11 of 18
A800-7425 J
4.5 OUTPUT SIGNAL NOT LINEAR, OR
ZERO SHIFTS DURING OPERATION
Check transducer and tension roll mounting. All
mounting bolts must be tight. Check that there is no dirt
or foreign matter interfering with the transducer
mounting.
4.6 NO OUTPUT SIGNAL
Check to see that all connections have been made
completely. Check for places where the connecting
cables might be crimped or cut. Verify that AC
Voltage is present from 1TB-3 to 1TB-4.
4.7 VERY HIGH OUTPUT WITH NO LOAD
Check cables and connectors for good connections and
check continuity of cables with an ohmmeter. Check for
proper wiring to transducers.
Check transducer gage resistance as given in the
transducer instruction manual.
5.0 REPLACEMENT PARTS
Description Use P/N
Lamp Power ON/OFF X01-21443
Switch, PB Power ON/OFF X16-11705
Lens, Red Power ON/OFF X01-21442
Lamp, 28V TLD X01-11702
Switch, PB TLD X16-11705
Lens, Orange TLD X16-13943
Lamp, 28V Dual Range X01-11702
Switch, PB Dual Range X16-11739
Lens, Orange Dual Range X16-13943
Switch, 3 Position TRL X16-09930
Knob TRL X01-13944
Fuse, 250V, .25A Circuit Board X21-07231
6.0 SERVICE ASSISTANCE AND
REPAIR
For additional service assistance, please obtain the
Type, MWF, and Serial Number from the nameplate.
Contact the Factory Service Department.
Phone: (216) 524-8800
Fax: (216) 642-5155
Disassembly by improperly trained personnel may result
in additional damage to these units. Should repairs be
required or for warranty repairs, contact the Customer
Service Department for a return authorization number
before returning the units.