Cleveland CycleWerks Tha Heist, Owner'S Manual, Page: 21 / 34

BRAKES
This motorcycle is equipped with front and rear hydraulic disc
brakes
. The brake fluid will drop as the brake pads wear or
if there is a leak . To ensure there are no leaks , check the
brake system often . Also check the brake pads for wear and
the fluid level.
If you feel abnormal free play in the brake lever , check for
wear on the brake pads . If you discover the brake pads to
be worn , replacement them immediately . If the pads are still
in good condition , there may be air in the brake system . Visit
your local Service Center for assistance .
Checking Brake Fluid Level:
•
Park the motorcycle on level ground in an upright posi-
tion .
•
Check the brake fluid level at the reservoir or the sight
window
. It should be above the lower mark . If if isn ' t , check
for wear on the brake pads . If the pads are worn , replace
immediately .
•
Make sure there are no leaks in the fluid lines .
•
Check for loose fittings or damage to the fluid lines .
A
WARNING:
Add DOT3 or DOT4 brake fluid only from a sealed con-
tainer. Do not mix brake fluid types. Failure to follow this
warning could cause the brakes to fail , resulting in serious
personal injury.
Checking Brake Pad Wear:
Brake padwear differs based on how often you usethe brakes ,
type of riding , and road conditions . Normally brake pads tend
to wear quicker on wet and dirty roads . Be sure to check the
pads for wear at each maintenance interval.
You can inspect the wear on the pads by using the wear
indicator mark . If the pads are worn , have them replaced
immediately at an authorized service center .