CLEOPATRA Cleo Steam Brain, Installation Manual

Page: 12 / 40

12
The electrical connection may only be carried out by a qualified electrician. For the electrical
installation the current applicable VDE, country specific and EU regulations must be observed.
All installation and test activities must be carried out by a qualified electrician and according to the latest
standards. Electrical outlets must be equiped with a breaker. The electricity network (230 VAC 50Hz or 400 VAC
50 Hz) to which components are connected must be equipped with a 30 mA fault current protector (earth
leakage breaker), as stated in the DIN EN 60335-2-41 / VDE 0700 standard. If the electrical connection cable is
damaged, it must be replaced. Turn off the power before you start working.
Local regulations must be observed. The steam generator must be installed in an area intended for this purpose.
This area must be equipped with adequate ventilation. During installation, a multi-pole main switch must be
installed with a contact distance of at least 3 mm.
The steam bath generator belongs to “Protection class I” (electrical divices) and must be connected via an earth
leakage breaker. The steam generator must be connected correct in the same way as all Class I devices.
Components that have a higher voltage than 12V must be installed out of reach of people for safety reasons. The
electricity scheme is attached. All connections must be done according to this scheme, respecting all regional and
national regulations. The work may only be carried out by a qualified electrician.
In the electrical scheme the maximum connection value of the external components is shown. These values may
not be exceeded. No modification may be made to the original wiring. External components may only be
connected to the appropriate clamps.
Connect all cables in accordance with NEN 1010.
9 Electrical connection
Circuit breaker
(Not included in delivery)
Electricity supply 230 / 400 V