3
The user manual must be given to the user.
Please read this user manual carefully before using the system and keep in a safe place for future
reference.
To reduce the risk of injuries, scalding and electrical shock, the safety precautions below must be instal-
led and followed
Use soft cloth, soapy solution and water for regular care. Wipe with a dry cloth.
Avoid the use of abrasives or solvents, which damage the surface.
Damage caused by inappropriate treatment by the user, is not covered by our guarantee.
Malfunctions, Possible cause, Solution
The device is not working.
Start Diagnostic. Check that:
−
The control unit is connected to the mains
−
There is no power supply failure
−
The electric plug inside the control unit is well connected
No water
fl
ow when activated. Check that:
−
Your faucet is connected to the water supply
−
Both angle valves are fully opened
−
Check another faucet in the house if water is running
−
The water supply hoses are not bent or twisted
−
The supply hoses might be soiled
−
The control unit is connected to the mains
Minimal water
fl
ow. Check that:
−
Both angle valves are fully opened
−
The water supply hoses are not bent or twisted
−
The supply hoses might be soiled
Continuous water
fl
ow
−
Press the ON/OFF button
−
Close angle valve or main valve
−
After a few minutes, open again. It’s still a continuous water
fl
ow, close
valve and contact your installer.
Risk of injury
This device is not intended for use by persons with different or reduced physical, sensory, or mental
abilities, or who lack experience or knowledge, unless they are under the supervision of or receive
training for the use of the device by a person responsible for their safety.
CONTINUOUSLY TURNING THE CONTROL WHEEL IN THE CLOCKWISE DIRECTION MAY
OVERRIDE THE PRE-SET MAXIMUM TEMPERATURE, RESULTING IN A RISK OF SCALDING.
If the power cord gets damaged, it must be replaced by the manufacturer, its authorized service agent or
quali
fi
ed personnel to avoid danger. Never operate the device with a damaged cable or plug! Do not
pull on the power cable as this could cause damage to the cable and cause electric shock.
Notice
