Page 11
After using the helmet it should be stored in a clean and dry area by hanging the respirator by the
handle.
8.1 Replacing Inner Lens
(1) Open frame.
Open latch and hang out frame.
(2) Remove inner lens.
Open window gasket in upper area from outside by hand.
With the other hand press out lens from inside.
Check that window gasket still fits well.
(3) Place new lens.
Clean gasket and moisten groove for lens with a mild soap-water.
Place new lens centred on gasket and push it roundabout into the
groove of the gasket by using the mounting-tool. Avoid scratches on the
lens! (See also picture 3).
(4) Close frame again.
Hook in frame in latch and close it.
8.2 Replacing Outer Lens and Perforated Cover Lenses
Up to five cover lenses may be installed at one time. For maximum visibility we recommend to install only
so many lenses to last during a work period.
Preparing lenses in the following manner will permit lenses to be pulled off easily by a user wearing heavy
gloves:
(1) Open frame.
Open latch and hang out frame.
(2) Remove outer lens.
Remove outer lens carefully from mushroom buttons.
(3) Remove used cover
lenses.
Remove perforated cover lenses respectively frame of used cover lenses
as well carefully from mushroom buttons.
(4) Place new perforated
cover lenses.
Place straps to hinge side and pull through all straps except the last and
press cover lenses on mushroom buttons.
(5) Place new outer lens.
When placing the new outer
lens look to it that there’s no dust or dirt be-
tween the lenses.
Press outer lens on mushroom buttons.
(6) Close frame again.
Hook in frame in latch and close it.
