Page 20
PL12EN-48ET
02/15/2013
Cleco
®
Repair Instructions
9
Repair instructions
9.1
Retainer nut spanner wrench
Use a spanner wrench with a 3/16” (4.76mm) pin to loosen or tighten the handle retainer nut and motor
housing lock nut.
9.2
Transducer identification
Transducers are not interchangeable. Verify the part number stamped on the transducer with the
transducer part number indicated in the parts list to assure the correct transducer is being used.
9.3
Wave washer assembly
The two wave washers, located in front of the motor assembly, must be assembled with their convex
surfaces facing each other.
Spanner Wrench
3/16” (4.76mm) Pin
Handle Retainer Nut
Motor Housing Lock Nut
Off
Part number stamped
on this end
Assembled
washer position
Wave Washers
Motor Assembly
