cleasby FIBERGLASS Series, Instruction Manual

Page: 91 / 112

Cleasby Conveyors Hydraulic Stabilizers
Cleasby Conveyors (Rev. 08/14/12) | Page 6-1
INTRODUCTION
Cleasby Conveyors, (CM) recommends stabilizers
be installed on all trucks with mounted conveyors.
Stabilizers provide (1) substantially improved
stability under all conditions; (2) permit use of the
conveyor when the ground is uneven; and (3) provide additional margins of safety against the
truck tipping over. All of this adds up to safer
operation and avoiding the possibility of injury or
damage to equipment.
PLEASE READ AND FOLLOW THE INSTALLATION PROCEDURE BELOW
INSTALLATION
Stabilizer Frame Mounting
(See Figure 7-1)
1.) Remove and discard the two knock-out braces
which were inserted for purposes of shipping.
2.) With the truck unloaded and located on level
ground, slide the open end of the stabilizer frame
upward over the truck chassis forward of the
turntable post.
3.) Block-up the stabilizer frame with the slides
vertical and the bottom of the frame approximately
twelve (12) inches off the ground (this may vary
depending upon the type of truck). The rear side of
the frame should be 6 to 12 inches forward of the
turntable post. Adjust position to avoid interference
with attachments to the chassis frame. The bottom
of the frame must be level in all directions.
4.) Weld the stabilizer frame to the chassis frame
and to the bed frame, if possible, using full weld
beads. Use eight beads with a minimum throat of
1/4 inch (See Figure 7-1).
(CM) recommends shielded arc welding to insure
adequate penetration. If only MIG welding is
available, use only at high heat. Only certified
welders should perform welding.
5.) Let cool. Clean weld and paint as necessary.
6.) Select a highly visible spot in the vehicle cab,
clean the area thoroughly and apply the warning
label supplied,
(See Section One, Warnings and
Cautions, Labels to Be Placed by you or the
Installer).
7.) Please see OSHA 29 CFR 1926.1400.