K. Scheduled Maintenance & Replacing the UV Bulb
(continued)
3. Carefully pull off the bottom panel and slide out the metal plate with the UV bulb and ballast
attached to it as far as it will go – approximately 11 inches. There is a tether holding it in place so
it will not completely disconnect from the ozone box. Be careful NOT to pull out any wires.
4. Cut the zip tie holding the bulb in the bulb clamp. Be careful NOT to break the bulb.
5. Carefully pull the bulb from the white connectors and the bulb clamp from holding them in place
and remove. Be careful NOT to break the bulb. Dispose of bulb properly after removal.
6. Snap new bulb in place. Secure with the metal brackets.
7. Push metal plate back into its place inside the unit. There is no need to add another zip tie as this
was used for shipping purposes.
8. Replace the bottom plate, making sure the gasket is seated in the groves properly.
9. Tighten the 6 screws back into place, securing the bottom plate tightly.
10. Reconnect power. Make sure the bulb indicator (the clear connector on the output tube of the
power box) glows in a blue color. Again, you may want to check this in the evening hours out of
direct sunlight.
L. Warranty Information
This unit comes with a 1-year warranty to be free from defects in material and workmanship under
normal use from the date of purchase. See warranty card (blue card) included.
Sustainable solutions for our future
Manufactured by
Phone: 727-562-5186 • Toll Free: 800-756-SWIM (7946)
ClearwaterPoolSystems.com
TM
Ozone
MAX
3
Vacuum-ultraviolet Ozone System
The Healthy Alternative to Chlorine
Designed, engineered
& assembled in the USA.
01/18