
2
A. Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions
should always be followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS
in this manual before attempting installation.
• A wire connector is provided on this unit to connect a minimum 12 AWG solid copper conductor between this unit and
any metal equipment, metal enclosures of electrical equipment, metal water pipe, or conduit within five (5) feet (1.5m)
of the unit.
• Follow all applicable electric codes.
• All permanent electrical connections should be performed by a qualified electrician.
• For cord and plug connected units:
“Risk of electric shock. Connect only to properly grounded, grounding type receptacle.”
• For cord and plug connected units:
“Do not bury cord.”
• For cord and plug connected units:
“Warning – To reduce the risk of electric shock, replace damaged cord immediately.”
• If electrically connecting this unit directly to pool controls, ensure the controls are protected by a (G.F.C.I.) Ground Fault
Circuit Interrupter.
• Install at least five (5) feet from wall of pool water using nonmetallic plumbing. Install ozone generator no less than one
(1) foot above the maximum water level to prevent water from contacting electrical equipment.
Install in accordance with the installation instructions.
• Mount the unit so that it is not accessible by anyone in the pool.
•
Electric Shock Hazard.
Disconnect unit from power source before attempting service.
•
WARNING:
Short term inhalation of high concentrations of ozone and long term inhalation of low concentrations of
ozone can cause serious harmful physiological effects. Do not inhale ozone gas produced by this device.
•
WARNING: UV Light is harmful to eyes and exposed skin.
Do not look directly at the Ozone producing bulb used in
this device.
B. Identifying OzoneMAX components
OZ-50
Power Box
OZ-VIM
Venturi Injection Kit
with Manifold
Owners
Manual
Warranty
Card
Indicator
Light
Output
Connector
4 Piece Molly Set
with #10 Screws