15
CLEARSPAN
™
SUPER MOO-TEL
Revision date: 03.16.12
2" x 2" Tubes
2" x 2" Tubes
END WALL INSTALLATION (CONTINUED)
Assemble the End Frame
After the door jambs are set, assemble the remainder of the
end frame.*
• Angled bracket (#QH1330) and 104624 fittings
• Carriage bolts and nuts and Tek screws (#FA4482B)
• 104188B (1/2" x 5-1/2" bolts), FALB08B (1/2" nuts),
FAMA40B (1/2" lock washers)
• Band clamps and 104074 brackets
• 4" x 4" square tube: 104263 (144")
• 2.0" x 2.0" square tube (105328) and 104075 inserts
*Refer to the End Wall diagrams for door framing and
connecting hardware.
Diagrams shown are specific to a
12' x 12' overhead door.
Complete the following steps:
1. Using the dimensions on the End Frame diagrams (or
for the doors if equipped) and the
4" x 4" square tubing
(104263)
, related hardware, and connectors, install the
door header.
NOTE:
The dashed lines above show where to install
the 4" x 4" square tubes. Consult the End Frame
diagram to properly position and connect the brackets.
Secure all 4" x 4" tubes using two (2) 105243 mounting
plates and 1/2" x 5-1/2" hex cap bolts. See diagrams.
(Bolts shown may differ from actual bolts.)
2. After the 4" x 4" door framing is installed, assemble the
remaining end wall framing using the 2.0" x 2.0" square
tubing (105328) and the related connectors.
NOTE:
The dashed lines identify the remaining 2" x 2"
end frame members to install. Cut tubes to length as
needed.
Splice the joints of the 2" x 2" tubes using a 104075
(1.75" x 1.75") square tube insert for each splice. Install
Tek screws to secure each splice.
Install the screws in a position that will not interfere with
the installation of additional end frame components, the
end panels or doors.
3. After assembling the end wall frame, inspect the frame
for sharp edges and bolts that could damage the end
panel or the main cover when it is pulled back into
place. Tape over or file the sharp edges as needed.
4. Once the end frame is prepared, install the main cover.
Ground Level
4" x 4" Tubes
4" x 4" Tubes
Header
#105243
Mounting Plate
104188B
Bolts
To prevent damage or possible injury or both, do
not attempt to pull cover on a stormy or windy
day or when such conditions are expected.
