6
Revision date: 06.04.10
End Panel Installation
END PANEL INSTALLATION (continued)
Secure the panel to the end frame brace using Tek
5.
screws and neo-bonded washers spaced every 6"
(see drawing A) in the panel valleys.
Do not install Tek
screws in the valley where the next panel overlaps the
first. See diagram B.
Select another 50" x 12' 2"
6.
panel and brace it in place,
overlapping the first lower panel by one (1) rib as
shown in drawing B.
Do not attach at this time.
Holding the panel in place, repeat steps 2 through 5
7.
to mark, trim, and attach panel to the end frame.
DO
NOT attach the top edge of the lower panel to the end
wall brace at this time. See dashed line in diagram
below.
NOTE:
Leave the innermost valley open for the
installation of the next panel; panels overlap by one
(1) rib. See diagram below for brace positions.
Continue attaching 50" x 12' 2" panels in this fashion
8.
until the bottom row of end panels is installed. Overlap
and cut the final panel to fit as needed.
Remember to account for the installation of the
sidewall panels if equipped. Position and cut final
panel as needed to create a finished corner. Diagrams
in the Quick Start section show a frame with sidewall
panels installed.
Valley–Install screws here.
Corrugated Panel
Brace
TOP VIEW
A
Rib
Corrugated Panel
No Tek screw in
this valley.
No Tek screw in
this valley.
Brace
TOP VIEW
B
GROUND LEVEL
50" x 12' 2"
panel
Brace
A
Trim
excess panels
Actual end frame and panels may differ from the 35' wide
frame shown below. Consult the panel diagrams located
in the Quick Start section for your end panel kit.
Do not attach lower panels to the end wall brace at
this time. Tek screws are installed after the upper
panels are cut and set into place. Upper panels
overlap lower panels. Typical overlap is 6".
Overlap and trim this panel as
needed. Remember to position
the panel so it meets the sidewall
panels if present. See the frame
diagrams in the Quick Start
section for sidewall position.
B
