CLEARSPAN
™
GARAGES & STORAGE SHEDS
8
Revision date: 06.11.08
RAFTER ASSEMBLY (CONTINUED)
3. With the main rafter pipes seated at each joint and the
rafter positioned on a flat surface, secure each joint
with a single self-tapping Tek screw. Position Tek screw
approximately 1" from pipe joint.
ATTENTION:
Install the screws so they will not touch
the cover once it is installed. This is typically on the
backside of the rafter, which will be the surface visible
from the
inside
of the shelter once the frame is
assembled.
4. Assemble rafters as described and continue with the
additional steps to complete the assembly of the two
end rafters.
END RAFTER ASSEMBLY
In addition to the steps in the previous procedure, complete
the following steps
for the two end rafters only
.
1. Take one of the assembled rafters and place it on a flat
surface.
2. Slide five (5) end clamps and two (2) band clamps onto
the rafter in the locations noted below. (Do not secure
the clamps to the rafter at this time. These clamps will
be repositioned during the frame assembly when the
purlins are added.)
NOTE:
All clamps must be positioned as shown. Use
a piece of duct tape to keep the clamps from sliding
when the rafter is set in place.
View of the end rafter and clamp as shown from the
outside
when the frame is assembled.
3. Repeat the same procedure for the final end rafter.
4. Continue with the FRAME ASSEMBLY instructions that
follow.
1˝
Tek screw
