6
t
echnIcal
s
upport
: 800.283.5936
optional Hd uSb CaMera beZel Mounting note
»
:
There are two methods
for mounting the HD Camera on a dual monitor Foot Stand system using the Camera
Bezel accessory kit.
The
recommended Method
provides a more natural conferencing experience with
the participants appearing to address each other as in a face-to-face discussion.
Position the camera so that it is centered over the Primary (Conferencing) Monitor.
Mount the Camera Bezel using the four #6-32 screws provided with the bezel kit.
The
optional Method
may make the participants appear to look away from each
other due to the location of the camera. Position the camera so that it is centered
between the Primary (Conferencing) and Secondary (Data Sharing) Monitors. Mount
the Camera Bezel using the four #6-32 screws provided with the bezel kit.. .
note
»
:
If using the Optional Method to mount the Camera Bezel, the surface
must be flat and level in order to properly align and install the Camera Bezel.
6. Plug the Collaborate Console and Display monitors into an electrical outlet.
7. Press the power buttons on the front of the Console and Display to turn the units on.
8. After boot-up has completed, configure the software if necessary (See the Software
Installation section.)
9. Adjust the camera using the camera adjustment screw as necessary. If using the optional
Camera Bezel, adjust the camera within the bezel.
10. Position the speaker if not mounted to the speaker bracket.
*Console shown with optional Camera Bezel.