I
nstallatIon
G
uIde
9
Clip the camera to the top of the Console then plug the camera into one of the USB ports
5.
located along the bottom of the Console.
note:
»
If mounting the camera with the optional Camera Bezel, use the four #6-32
screws that come with the bezel kit to mount the bezel as shown above. Connect the
Collaborate Camera as shown on page 4. If using the optional Camera Bezel, adjust
the camera within the bezel.
Mount the Collaborate Console onto the TV Wall Mount bracket (See TV Wall Mount
6.
manufacturers instructions.)
Plug the power cable into an outlet.
7.
Press the Collaborate Console power switch located on the front to turn the unit on.
8.
Once the system has completed bootup, configure the Collaborate Software if necessary.
9.
Adjust the camera using the camera adjustment screw as necessary.
10.
W
all
-m
ount
a
ssemBly
(d
ual
m
onItor
)
Install the two TV Wall Mount Kits as specified by the manufacturers’ documentation onto
1.
the intended wall location.
iMportant
»
: Space the brackets appropriately to ensure the desired distance
between the two monitors is achieved. Cable length should also be considered prior
to installing the wall mount brackets.
Place the Collaborate Console and Display face-down on a flat, clean, soft, non-abrasive
2.
surface and attach the Collaborate Wall Mount Brackets onto the appropriate mounting
holes on the back of each Collaborate unit (Refer to the manufacturers TV Wall Mount Kit
documentation for appropriate bracket hole locations.)
Review the port locations on page 2 and make the appropriate cable connections. Keep
3.
in mind that most cable connections may need to be completed after the two units are
mounted to the wall.
*Product shown with optional Camera Bezel.