The Door can be installed either le or right hand hinged by simply rota ng 180 degrees.
Important : The Door must always open outwards
Installing a Door Only
Installing the Wall Receivers
1. Place the Wall Receiver hard against the inside
edge of the tray upstand. Using a spirit level en-
sure the Wall Receiver is plumb. Mark the posi on
of the Wall Receiver on the wall. Repeat for the
opposite side
2. Pre drill three equally spaced clearance holes (i.e.
top, bo om and centre) in the Wall Receivers us-
ing a 4.5mm drill bit. Reposi on the Wall Receivers
onto the wall. Drill into the wall through the clear-
ance holes using a 3.0mm drill bit.
N.B. The holes preferably locate into a stud or nog.
As an alterna ve, a toggle system can also be used.
3. Apply Silicone into the screw holes and secure the
Wall Receivers to the walls using the No.6 x 38mm
stainless steel screws.
Installing the Door
4. Slide the door assembly together so it is narrower
than the opening.
Do not remove the door se ng block, this will assist in
suppor ng the door during installa on and se ng the
correct clearance from the sill
