Secure the head and Sills
9. From the inside drill a 3.0mm hole approximately
25mm in from the end of the Female Head and
Sill sec ons and into the Male Head and Sill sec-
ons.
10. Secure the sec ons together using No.6 x 10
Stainless steel screws.
11. Cover the screws heads with the cover caps.
12. Slide the outside Clamp Block Covers off the Pivot
Clamp. Using a flat blade screwdriver sufficiently
loosen the two screws , adjust the door by sliding
le or right in the pivot
Once the door adjustment is complete ensure the
screws are re ghtened and reinstall the Clamp
Block Covers. Open the door and remove the
door se ng block
