Key to CPU card interface connectors
Feature
Description
A
GPI/RLY Interface Connector
The RJ-45 socket labeled
GPI/RLY Interface
connects the CPU card to a
GPI-6 or RLY-6 card. The GPI-6 provides six general-purpose opto-isolated
logic inputs. The RLY-6 card provides six single-pole, double-throw relay
outputs.
Both card types mount in either an IMF-3 interface frame or an IMF-102
interface frame. Up to ten GPI-6 or RLY-6 cards can be operated at one
time from the matrix by daisy-chaining the cards together. Each card has an
IN and an OUT connector for this purpose.
The RLY-6 and GPI-6 cards connect to the GPI/RLY interface connector
using shielded category-5 cable. For more information about the GPI-6 and
RLY-6 cards, consult their respective manuals in the Eclipse HX
documentation set.
Note:
If this port is used a ferrite core must be added to the socket end of each
cable. A suitable ferrite core is Würth Electronik part: 74271132.
Clear-Com recommends the use of shielded cable.
For wiring pinout information for GPI/RLY interfaces, see:
•
The
Relay Interface Module (RLY-6) Instruction Manual
.
•
The
General Purpose Inputs (GPI-6) Instruction Manual
.
B
RS-232 DB-9 Connector
The DB-9 connector labeled RS-232 connects the Eclipse HX-Median
matrix to an external computer. To connect a computer to the matrix, run
cable from the RS-232 connector to the PC’s serial port. The maximum
recommended length of the cable is approximately 10 feet (3 meters). A
computer has either a 9-pin serial port or a 25-pin serial port.
44
Eclipse HX-Median User Guide
Summary of Contents for Eclipse HX-Omega
Page 1: ...Eclipse HX Median User Guide PN 399G060 Rev A 08 22 13...
Page 8: ...8 Eclipse HX Median User Guide...
Page 16: ...Figure 2 Eclipse HX Median front panel C B D A 16 Eclipse HX Median User Guide...
Page 18: ...Figure 3 Eclipse HX Median rear panel A B C D E 18 Eclipse HX Median User Guide...
