20
Attaching/Detaching the Floor Nozzle, Brush Nozzle and Crevice Nozzle
1. Plug the nozzle adapter onto the suction opening.
2. If you wish, plug the extension suction tubes onto the nozzle adapter.
3. Plug the
fl
oor nozzle or the brush nozzle or the crevice nozzle onto the extension
suction tube.
The nozzles can also be plugged directly onto the adapter without placing
the extension suction tubes in between.
4. When you want to detach the nozzles, simply pull them off the adapter or the exten-
sion suction tubes.
Attaching/Detaching the 8-Piece Accessory Set
1. Plug the nozzle adapter onto the suction opening.
2. Plug the accessory nozzle adapter onto the nozzle adapter.
3. Select an accessory nozzle and plug it onto the accessory nozzle adapter.
4. When you want to detach the accessory nozzles, simply pull them off the accessory
nozzle adapter.
Use
CAUTION!
❐
The openings on the device must not be blocked to ensure that the motor does not
overheat or suffer damage.
❐
Never hold the nozzles close to parts of your body or animals during use and do not
place your hands inside the nozzles. They could become stuck to the device / injured.
Should the vacuum cleaner become stuck, switch the device off immediately.
❐
Switch on the vacuum cleaner only when you have checked that all the parts have
been fully attached and that the dust container and the
fi
lters are correctly inserted.
❐
Always switch the device off
fi
rst and pull the mains plug from the mains socket be-
fore you replace the nozzles and any other accessories!
❐
On no account should the device be used to suck up the following:
–
Liquids or wet substances (e.g. wet carpet shampoo)
–
Glowing ash, cigarette ends, matches, etc.
–
In
fl
ammable or explosive substances
–
Very
fi
ne dust (e.g. concrete dust), ash or toner
–
Pointed, hard objects such as large pieces of broken glass
1. Select a nozzle and attach it in the manner described in the "Attaching and Detaching
Accessories" chapter.
2. Unwind the mains cable to its full length and insert the mains plug into a properly
installed mains socket that is easily accessible.
3. Move the On/Off switch to the
1
position to switch on the vacuum cleaner.
4. Guide the nozzle over the surface to be cleaned.
09294_de-gb-fr-nl_V0.indb 20
09294_de-gb-fr-nl_V0.indb 20
30.10.2014 12:05:44
30.10.2014 12:05:44
